Accord & Odyssey

WARNING: This page is about a different car, the 2001 Honda Prelude, 2001 Honda Odyssey, 2001 Honda CR-V, and 2001 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Remove driver's side lower instrument panel cover. Disconnect 6-pin connector from steering column harness. Check continuity between specified connector terminals, with ignition switch in appropriate position. See Fig 1 and Fig 2 . If continuity is not as specified, replace ignition switch.

Fig 1: Testing Ignition Switch Continuity (Accord & Odyssey)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Ignition Switch Terminal Continuity Table (Except Civic & S2000)

Courtesy of AMERICAN HONDA MOTOR CO., INC.