LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Engine Cooling System Specifications And Drive Belt Routing) >> Cooling System Bleeding >> Prelude

Cooling System Bleeding: Prelude

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 Honda Odyssey, 2000 Honda Insight, 2000 Honda Civic, 2000 Honda Accord, and 1999 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set heater controls to maximum heat. Fill cooling system with a 50/50 mixture of coolant and water to bottom of filler neck. Loosen air bleed bolt located on thermostat housing.
  2. Tighten bleed bolt when coolant flows from bleed bolt in steady stream without bubbles. With radiator cap off, start and operate engine to normal operating temperature (fan comes on at least twice). Add coolant as necessary. Install radiator cap.
scientia non olet · About LEMON Manuals