Disassembly (Front & Rear)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2001 Isuzu VehiCROSS, 2001 Isuzu Trooper, 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, and 1999 Isuzu VehiCROSS. However, it is still accessible from the selected car via links, so may be relevant.
Remove bleed valve and drain brake fluid. Remove guide pin and caliper bolt dust boots as required. Remove piston dust boot seal ring (if equipped) and dust boot. See Figure . Place wood block between piston and caliper wall. Using compressed air, force piston from caliper bore. Remove piston seal ring.