LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Disc Brakes) >> Bleeding Brake System >> Bleeding Procedure >> Master Cylinder

Master Cylinder

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2001 Isuzu VehiCROSS, 2001 Isuzu Trooper, 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, and 1999 Isuzu VehiCROSS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Check fluid level in master cylinder frequently during bleeding sequence. Fluid level must remain at least half full at all times.
  1. Clean master cylinder cap and surrounding area, and then remove cap. Fill master cylinder, keeping fluid level at least half full during bleeding procedure. Start engine and allow it to idle.
  2. Disconnect rear wheel brakeline from master cylinder (line furthest from brake booster). Depress brake pedal once slowly and hold depressed. Seal open delivery port on master cylinder with finger and release brake pedal. Remove finger when brake pedal returns completely. Repeat procedure until brake fluid flows from delivery port.
  3. Reconnect brakeline to master cylinder. Depress brake pedal once slowly and hold depressed. Loosen rear wheel brakeline at master cylinder to allow air to escape. Tighten brakeline and release brake pedal slowly. Repeat procedure until air bubbles are no longer present. Repeat entire procedure for front wheel brakeline, and then bleed calipers.
scientia non olet · About LEMON Manuals