LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Disc & Drum) >> Removal & Installation >> Automatic Locking Hub >> Removal

Automatic Locking Hub: Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Isuzu Rodeo Sport, 2001 Isuzu Rodeo, 2001 Honda Passport, 2000 Isuzu Rodeo, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Select 2WD position with 4WD switch. Raise and support vehicle. Remove wheel and brake caliper. Wire caliper aside. Remove 6 bolts and locking hub cover. See Figure .
  2. Remove snap ring and shim. Remove hub flange. Remove lock screw and lock washer. Using Hub Nut Wrench (J-36827), remove hub nut. Remove outer bearing with hub and rotor assembly. Mark hub and rotor relation if they are to be separated.
scientia non olet · About LEMON Manuals