Disassembly (Front & Rear)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Isuzu Rodeo Sport, 2001 Isuzu Rodeo, 2001 Honda Passport, 2000 Isuzu Rodeo, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
Remove bleed valve and drain brake fluid. Remove guide pin and caliper bolt dust boots as required. Remove piston dust boot seal ring (if equipped) and dust boot. See Figure . Place wood block between piston and caliper wall. Using compressed air, force piston from caliper bore. Remove piston seal ring.