LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Disc & Drum) >> Bleeding Brake System >> Bleeding Procedure >> Calipers & Wheel Cylinders (Pressure Bleeding)

Calipers & Wheel Cylinders (Pressure Bleeding)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Isuzu Rodeo Sport, 2001 Isuzu Rodeo, 2001 Honda Passport, 2000 Isuzu Rodeo, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and allow it to idle. Clean master cylinder cap and surrounding area, and then remove cap. With pressure tank at least 1/2 full, connect tank to master cylinder using appropriate adapter(s).
  2. Attach bleed hose to first wheel cylinder or caliper bleed screw to be serviced. See BRAKELINE BLEEDING SEQUENCE  table. Place other end of hose in clean transparent container. Partially fill container with clean brake fluid until end of hose is submerged in fluid.
  3. Open release valve on pressure tank. Open bleed screw, noting fluid flow. When fluid flowing into container is clear and bubble free, close bleed screw securely.
  4. Finish bleeding system in the same manner using correct sequence. Close release valve, and then remove pressure tank from master cylinder. Check fluid level of master cylinder reservoir.
BRAKELINE BLEEDING SEQUENCE

Application Sequence
All Models RR, LR, RF, LF
scientia non olet · About LEMON Manuals