LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Power Recirculating Ball) >> Overhaul >> Power Steering Pump >> Reassembly (Hombre)

Reassembly (Hombre)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Hombre, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate NEW drive shaft seal with power steering fluid, and drive seal into pump housing using Seal Driver (J-7728). See Fig 1. Install pump ring dowel pins into pump housing. Assemble thrust plate and pump rotor onto drive shaft. Fit NEW retaining ring to shaft. See Fig 2.
    Fig 1: Installing Drive Shaft Seal (Hombre)
    G94E65486Courtesy of GENERAL MOTORS CORP.
    Fig 2: Assembling Drive Shaft Sub-Assembly (Hombre)
    G94F65487Courtesy of GENERAL MOTORS CORP.
  2. Install drive shaft subassembly into pump housing. Install vanes into pump rotor. With holes positioned correctly onto dowel pins, install pump ring into pump housing.
  3. Lubricate NEW "O" ring with power steering fluid and install into pump body. Install pressure plate and pressure plate spring.
  4. Lubricate NEW "O" ring with power steering fluid and install into end cover. Lubricate outer edge of end cover with power steering fluid. Press end cover into pump housing. When installing retaining ring into groove, ensure opening of ring is near access hole in pump housing. See Fig 3.
Fig 3: Installing End Cover & Retaining Ring (Hombre)
G94G65488Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals