LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Power Recirculating Ball) >> Overhaul >> Power Steering Gear >> Reassembly (Hombre)

Reassembly (Hombre)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Hombre, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate components with power steering fluid before reassembly. Install valve body, stub shaft and worm shaft assembly into housing.
  2. Place seal protector over stub shaft. Install adjuster plug until it seats against valve body. Remove seal protector from housing and loosely install adjuster plug lock nut. Insert rack piston (with arbor to retain recirculating balls) into housing. Align worm shaft and rack piston. Turn stub shaft clockwise to engage worm shaft. Maintain pressure on arbor until worm shaft is fully engaged. Remove arbor.
  3. Install NEW pitman shaft side cover gasket. Thread pitman shaft side cover onto adjuster screw until it bottoms. Back off 1/2 turn. Install pitman shaft so center sector gear tooth meshes with center groove in rack piston. Install side cover bolts.
  4. Install adjuster screw lock nut halfway onto pitman shaft. Install rack piston end plug in rack piston. Install housing end plug seals, ring, end plug and retaining ring. Adjust worm shaft bearing preload and over-center preload. See WORM THRUST BEARING PRELOAD  and PITMAN SHAFT OVER-CENTER PRELOAD  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals