LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Front Suspension) >> Removal & Installation >> Torsion Bar >> Installation (Amigo, Rodeo (Passport), Trooper (SLX) & VehiCROSS)

Installation (Amigo, Rodeo (Passport), Trooper (SLX) & VehiCROSS)

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2001 Isuzu VehiCROSS, 2001 Isuzu Trooper, 2001 Isuzu Rodeo Sport, 2001 Isuzu Rodeo, and 2001 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply grease to splined areas of torsion bar. Install torsion bar in lower control arm. Ensure torsion bar is installed in proper location by aligning marks made during removal.
  2. Apply grease to height control arm-to-bracket contact areas. Install height control arm on torsion bar. Ensure alignment marks made during removal align. Install adjusting bolt.
  3. Rotate adjusting bolt until alignment marks (made during removal) on adjusting bolt and height control arm align. Check riding height. See RIDING HEIGHT  under ADJUSTMENTS & INSPECTION. On 2WD models, install lock plate. On all models, tighten fasteners to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals