LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Disc & Drum) >> Testing >> Combination Valve

Combination Valve

WARNING: This page is about a different car, the 2000 Isuzu Hombre and 1999 Isuzu Hombre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure master cylinder is full. Raise and support vehicle. Install bleed hose to a rear bleed screw. Place other end of hose in clean container. Partially fill container with clean brake fluid so end of hose is submerged in fluid. Turn ignition switch to ON position.
  2. Open bleed screw while an assistant slowly depresses brake pedal. Brake warning light should illuminate. Before releasing brake pedal, close bleed screw. If warning light does not illuminate, go to step  4 . Reapply brake pedal and ensure warning light turns off.
  3. Attach bleed hose to a front bleed screw. Turn ignition switch to ON position. Open bleed screw while an assistant slowly depresses brake pedal. Brake warning light should illuminate. Before releasing brake pedal, close bleed screw. If warning light does not illuminate, go to next step. Reapply brake pedal and ensure warning light turns off.
  4. If warning light does not illuminate in steps 2)  or 3)  , connect jumper wire between combination valve wiring connector and ground. If warning light illuminates, warning switch portion of combination valve is faulty. Replace valve. DO NOT disassemble combination valve.
scientia non olet · About LEMON Manuals