LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Removal, Overhaul & Installation) >> Fuel System >> Idle Air Control (IAC) Valve >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Hombre, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable and IAC electrical connector. Remove hold-down bolts and IAC valve from throttle body.
  2. Using carburetor cleaner, clean IAC valve "O" ring sealing surface, pintle valve seat and air passage.
  3. When installing new IAC, inspect IAC valve "O" ring and check distance between tip of pintle and mounting flange. If measurement is greater than 1.1" (28 mm), apply finger pressure and retract valve to 1.1" (28 mm). To install, reverse removal procedure and tighten bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals