LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Removal, Overhaul & Installation) >> Fuel System >> Accelerator Cable (2.2L Amigo & Rodeo, 3.2L & 3.5L) >> Adjusting Cable At Throttle Body

Adjusting Cable At Throttle Body

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Hombre, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen adjusting and jam nuts. Pull on cable while fully closing throttle valve. Tighten adjusting and jam nuts.
  2. Loosen adjusting nut 3 turns. Tighten jam nut. Valve lever must return upward to stopper screw. If valve lever does not reach stopper screw, repeat adjustment procedure.
scientia non olet · About LEMON Manuals