LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Crankshaft Position (CKP) Sensor >> Removal & Installation (4.3L)

Removal & Installation (4.3L)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Hombre, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Raise and support vehicle. Remove undercarriage splash shield. Remove steering linkage shield. Remove crankshaft position sensor wiring connector located on right side of timing cover.
  2. Remove sensor mounting bolt. Remove sensor. Before installing new sensor inspect "O" ring for damaged or wear, and replace if necessary. Ensure mounting surfaces are clean and free of burrs.
  3. To install, lubricate "O" ring with engine oil and reverse removal procedure. Ensure sensor is properly seated. Tighten bolt to specification. See TORQUE SPECIFICATIONS .
    NOTE: Ensure CKP sensor is fully seated and held stationary in front cover. Erratic operation and setting of false codes may result if not seated properly.
scientia non olet · About LEMON Manuals