LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Camshaft Position (CMP) Sensor >> Removal & Installation (2.2L Hombre)

Removal & Installation (2.2L Hombre)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Hombre, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Raise and support vehicle. Remove right wheel. Disconnect CMP electrical connector. Remove sensor mounting bolt and sensor.
  2. To install, lubricate NEW "O" ring with engine oil and reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals