LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls - Self-Diagnostics - 4.3L) >> Diagnostic Trouble Code Identification >> DTC P1626: Loss Of Serial Communication Vehicle Theft Deterrent (VTD) >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2000 Isuzu Hombre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform On-Board Diagnostic II (OBD-II) System Check. See SELF-DIAGNOSTICS - INTRODUCTION article. Retrieve and record FREEZE FRAME and/or FAIL RECORDS data for each DTC set. Go to next step.
  2. Install scan tool. Turn ignition on, with engine off. Attempt to establish communication with VTD control module. If scan tool communicates with VTD control module, go to next step. If scan tool does not communicate with VTD control module, see ANTI-THEFT SYSTEMS - HOMBRE article in ACCESSORIES & EQUIPMENT.
  3. Select ATC CONTROL MODULE function on scan tool. Check for DTC P1626. If DTC P1626 is stored in memory, see ANTI-THEFT SYSTEMS - HOMBRE article in ACCESSORIES & EQUIPMENT. If DTC P1626 is not stored in memory, go to next step.
  4. Check class II serial data circuits at VCM connector C4 terminals No. 11 (Dark Green wire) and No. 14 (Yellow wire) for an intermittent open circuit, short to ground, short to voltage, or loose or damaged terminals. Repair as necessary. If a problem was not found, go to next step.
  5. Ensure ignition is off. Reconnect all electrical connectors. Clear DTCs. Turn ignition off for 15 seconds. Turn ignition on, engine off. If DTC does not reset, problem is intermittent. If DTC P1626 resets, replace VCM. Perform password learn procedure. See PASSWORD LEARN PROCEDURE in ANTI-THEFT SYSTEMS - HOMBRE article in ACCESSORIES & EQUIPMENT.
scientia non olet · About LEMON Manuals