LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls - Self-Diagnostics - 4.3L) >> Diagnostic Trouble Code Identification >> DTC P0341: Camshaft Position Sensor Circuit >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2000 Isuzu Hombre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform On-Board Diagnostic II (OBD-II) System Check. See SELF-DIAGNOSTICS - INTRODUCTION article. Retrieve and record FREEZE FRAME and/or FAIL RECORDS data for each DTC set. Go to next step.
  2. Check for intermittent short to voltage or Electromagnetic Interference (EMI) at CMP sensor wiring. Check for wiring alongside spark plug wires or high power transistors (mobile radios operating nearby). If problem is found, go to next step. If no problem is found, go to step  4.
  3. Repair short to voltage or correct EMI interference. After repair, go to next step.
  4. Using scan tool, select DTC, CLEAR INFO function. Start engine and allow it to reach operating temperature. Using scan tool, select DTC, SPECIFIC function and enter DTC P0341. Operate vehicle within conditions required to set DTC. If scan tool displays RAN AND PASSED, go to next step. If scan tool does not display RAN AND PASSED, return to step  2.
  5. Using scan tool, select Read and Record INFO, REVIEW INFO function. If any undiagnosed DTCs are displayed, diagnose affected DTCs. If no DTCs are displayed, system is okay.
scientia non olet · About LEMON Manuals