Removal & Installation
- Raise and support vehicle. Remove wheels. Remove caliper assembly. See REAR BRAKE CALIPER . Suspend caliper using wire. Remove caliper bracket mounting bolts and bracket. Attach dial indicator to control arm assembly. Check disc runout before removal. See DISC BRAKE SPECIFICATIONS .
- Remove spindle nut. Detach and remove two 6-mm disc retaining screws. Install two 8 x 1.25 x 12-mm bolts in existing holes. To prevent warpage, alternately turn bolts 2 turns at a time until disc can be removed from hub.
- Clean disc of all rust, and inspect disc surfaces for excessive wear, cracks and grooves. Resurface or replace disc as necessary. To install, reverse removal procedure. Install NEW spindle nut. Tighten retaining screws. Bleed hydraulic system (if necessary). See BLEEDING BRAKE SYSTEM .