Left Mirror Inoperative
- Remove power mirror switch. Disconnect switch from harness. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Turn ignition on. Using jumper wires, connect terminal No. 1 (Black/Blue wire) to terminal No. 7 (Blue/Black wire), and either terminal No. 4 (Yellow/Red wire) or terminal No. 9 (Blue/White wire) to ground. See Figure.
- If mirror does not tilt down (or swing left), check for open in Yellow/Red wire or Blue/White wire between mirror switch and left mirror. If wiring is okay, check left mirror actuator. See POWER MIRROR ACTUATOR under COMPONENT TESTS. If mirror does not tilt down and does not swing left, repair open in Blue/Black wire between power mirror switch and power mirror actuator. If mirror operates correctly, check mirror switch. See POWER MIRROR SWITCH under COMPONENT TESTS.