LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> NIPPONDENSO (DENSO) >> Clutch Coil >> Removal (Suzuki)

Removal (Suzuki)

  1. Remove compressor shaft bolt and discard, while holding clutch plate with Clutch Holder (09991-06020). Remove clutch plate using Clutch Plate Remover (09991-06030). Remove shim(s). See Figure.
  2. Remove pulley snap ring. Install a 2-jaw puller to outer diameter of pulley and Shaft Protector (09951-65510) to compressor boss, and remove pulley. DO NOT engage puller on belt area. Hold puller in place and tighten screw to remove pulley. Disconnect clutch coil lead from compressor housing. Remove clutch coil snap ring and clutch coil.
scientia non olet · About LEMON Manuals