Left Mirror Inoperative
- Remove power mirror switch. Disconnect switch from harness. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Turn ignition on. Using jumper wires, connect terminal No. 2 (Black/Yellow wire) to terminal No. 3 (Yellow/Red wire), and either terminal No. 5 (Blue/White wire) or terminal No. 6 (Blue/Black wire) to ground. See Figure or Figure .
- If mirror does not tilt down (or swing left), check for open in Blue/White wire or Blue/Black wire between mirror switch and mirror. If wiring is okay, check left mirror actuator. See POWER MIRROR ACTUATOR under COMPONENT TESTS. If mirror does not tilt down and does not swing left, repair open in Yellow/Red wire between power mirror switch and power mirror actuator. If mirror operates correctly, check mirror switch. See POWER MIRROR SWITCH under COMPONENT TESTS.