LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Power Door Locks & Trunk Release >> Component Tests >> Passenger's Door Lock Actuator

Passenger's Door Lock Actuator

NOTE: This test also applies to rear doors.
  1. Remove affected door panel. Turn ignition off. Disconnect door lock actuator 2-pin harness connector. Set door lock switch to UNLOCK position. Connect battery voltage to terminal No. 2 (White/Red wire) of door lock actuator harness connector. Momentarily connect jumper wire between ground and terminal No. 1 (Yellow/Red wire) of door lock actuator harness connector. Actuator should operate. If actuator does not operate, replace actuator.
  2. Set door lock switch to LOCK position. Connect battery voltage to terminal No. 1 (Yellow/Red wire) of door lock actuator harness connector. Momentarily connect jumper wire between ground and terminal No. 2 (White/Red wire) of door lock actuator harness connector. Actuator should operate. If actuator does not operate, replace actuator.
scientia non olet · About LEMON Manuals