LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1998 >> Prelude Base, Automatic >> Labor Times >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All,Both Axles,w/Rear Disc Brakes1.8B
Front,Both Sides1.0B
Rear,Both Sides,w/Disc Brakes1.0B
Combination Procedure: CALIPER: Overhaul:
Includes: Bleed Brake System.
One,w/ABS0.7B
Combination Procedure: CALIPER: Replace:
Includes: Bleed Brake System.
One,w/ABS0.5B
One,w/o ABS0.3B
Combination Procedure: DISC ROTOR: Remove and Install for Refinishing:
This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation.
Not Applicable.B
Combination Procedure: DISC ROTOR: Replace:
FrontNot Applicable.B
RearNot Applicable.B
Combination Procedure: WHEEL BEARING: Repack:
FWDRefer to Front Wheel Bearing - R&R.B
Combination Procedure: WHEEL BEARING: Replace:
FWD, FrontRefer to Front Wheel Bearing - R&R.B
Combination Procedure: WHEEL SEAL: Replace:
FrontRefer to Front Wheel Bearing - Repack.B