Brake System (Complete): Remove & Replace
WARNING: This page is about the Passport EX, 4WD, Automatic, which is a different variant/trim than selected.
Includes: Replace Calipers and/or Wheel Cylinders, Brake Shoes and/or Pads. Clean, lube and/or replace Brake Hardware as necessary. Inspect Master Cylinder, all Hoses and bleed Brake System. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All Wheels,w/Rear Disc Brakes | 2.6 | B | ||
| All Wheels,w/Rear Drum Brakes | 3.0 | B | ||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation. | ||||
| 4WD, Front | 0.7 | B | ||
| Rear | Not Applicable. | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| 4WD, Front,Each | 0.7 | B | ||
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| 0.6 | B | |||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| 4WD, Front,One Side | Refer to Front Wheel Bearing - R&R. | B | ||
| Combination Procedure: WHEEL SEAL: Replace: | ||||
| Front | Refer to Front Wheel Bearing - R&R. | B | ||