Front Wiper Switch

With switch in "OFF" position, there should be continuity between "Int. A" (Blue/White) and "Low" (Blue) terminals. See Figure .
With switch in "INT" position, there should be continuity between "IG 1" (Green/Black) and "Intermittent" (Green) terminals. Also, there should be continuity between "Int. A" (Blue/White) and "Low" (Blue) terminals.
With switch in "LO" position, there should be continuity between "Low" (Blue) and "Gnd" (Black) terminals.
With switch in "HI" position, there should be continuity between "High" (Blue/Yellow) and "Gnd" (Black) terminals.