LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1983 >> Prelude Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL, 1.5L 4-CYL, 1.75L 4-CYL & 1.8L 4-CYL >> Engine Cooling >> Water Pump >> Installation

Water Pump: Installation

  1. Reinstall water pump. Loosen cooling system bleed valve located on thermostat housing. Fill radiator with coolant. When air bubbles no longer appear in coolant, close bleed valve.
  2. Start engine. Set heater temperature control lever to high position. Run engine 10 minutes, and open bleed valve again. Allow coolant to drain from bleed valve until air bubbles disappear, then close valve. Refill radiator.
scientia non olet · About LEMON Manuals