LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1983 >> Prelude Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Steering Gear - Manual >> Removal & Installation >> Steering Gear >> Removal (Accord)

Removal (Accord)

  1. Remove steering shaft connector bottom bolt. Pull connector off pinion shaft. Raise and support front of vehicle. Remove front wheels.
  2. Remove cotter pins and ball joint nuts. Using a ball joint remover, remove tie rod ends from steering knuckles.
  3. Place manual transmission in 1st or 3rd and remove shift rod yoke bolt. Remove engine crossmember. Disconnect shift lever torque arm from manual transmission.
  4. Remove exhaust manifold-to-header pipe nuts. Push rack to extreme right (simulate a left turn). Remove gearbox brackets. Lower the gearbox so pinion shaft end comes out of frame hole.
  5. Rotate gearbox 180° forward until pinion shaft points rearward. Move gear right until left tie rod clears exhaust pipe. Remove through left side of vehicle.
scientia non olet · About LEMON Manuals