LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1997 >> Tracker Base, 4D Utility, 4WD, Standard >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Axle Shafts >> 1997-98 Drive Axles Geo/SUZUKI >> Removal, Disassembly, Reassembly & Installation >> Esteem & Swift >> Reassembly

Esteem & Swift: Reassembly

  1. Grease outer CV joint fully. Position boot on shaft and fill inside of boot with about 3 ozs. (90 g) of grease. Install inner CV joint boot onto axle shaft. Install inner CV joint onto shaft, ensuring smaller outside diameter of cage faces outer CV joint.
  2. Install snap ring into shaft groove. Fill inside of boot with grease. Attach boots using boot bands. Ensure boot band clamp end is bent in a reverse direction of rotation. If boots are distorted or dented, correct before installing on vehicle.
  3. To install center bearing and shaft, reverse removal procedure. Install circlip securely into groove of bearing support. Apply grease to oil seals.
scientia non olet · About LEMON Manuals