LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1996 >> Tracker Base, 4D Utility, 4WD, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Adjustments >> Brake Pedal Travel >> Tracker

Brake Pedal Travel: Tracker

  1. With engine off, depress brake pedal several times to exhaust vacuum from power brake unit. Depress brake pedal using approximately 66 lbs. (30 kg) pressure on pedal. Measure from floor board to rear of brake pedal. See Figure .
  2. Brake pedal-to-floor board distance with pedal depressed should be 3.15" (80 mm) or greater on 1995 models, or 5.12" (130 mm) on 1996 models. If distance is less than specified, problem may be rear brakes out of adjustment or worn out, front pads worn out, defective master cylinder or air in brake system.
scientia non olet · About LEMON Manuals