LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1996 >> Prizm Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission Diagnosis - A-240 "E" Series) >> Diagnostic Tests >> DTC 62 Or DTC P0753: No. 1 Solenoid

DTC 62 Or DTC P0753: No. 1 Solenoid

WARNING: This page is about a different variant/trim than selected.
  1. Access ECT ECU. See Figure-8. Using ohmmeter, check resistance between terminal S1 and body ground with connector removed from ECT ECU. See Figure.
  2. Resistance should be 11-15 ohms. If resistance is okay, replace ECT ECU. If resistance is not within specification, remove transaxle oil pan. Disconnect electrical connector at No. 1 solenoid. See WIRING DIAGRAMS .
  3. Check resistance between electrical terminal on No. 1 solenoid and body ground. Replace No. 1 solenoid if resistance is not 11-15 ohms. If resistance is 11-15 ohms, inspect and repair wiring between No. 1 solenoid and ECT ECU.
scientia non olet · About LEMON Manuals