LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1994 >> Tracker Base, 1.6 6, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VINS [U,6] >> Removal & Installation >> Rocker Arm Shafts >> Removal (16-Valve)

Removal (16-Valve)

  1. Disconnect negative battery cable. Remove front grille and header panel. Remove timing belt. See TIMING BELT  under REMOVAL & INSTALLATION. Remove camshaft sprocket. Remove valve cover, distributor and distributor housing.
  2. Loosen all valve adjusting screw lock nuts and adjusting screws until valves are fully closed. See Figure. Remove camshaft. See CAMSHAFT  (16-Valve) under REMOVAL & INSTALLATION.
    CAUTION: On 16-valve engines, camshaft can be damaged if camshaft carrier bolts are removed randomly. Loosen camshaft carrier cap bolts gradually in reverse order of tightening sequence. See Figure.
  3. Remove rocker arm shaft plug from front of head and timing belt inside cover. Remove intake rocker arms with clips from rocker arm shaft. Remove rocker arm shaft retaining screws. Push rocker arm shaft through rear of head until end is exposed.
  4. Remove rocker arm shaft "O" ring. Note location of rocker arm components for reassembly reference. Remove exhaust rocker arms, springs and rocker arm shaft by sliding rocker arm shaft out of front of head. See Figure. Keep components in order removed to ensure installation in original position.
scientia non olet · About LEMON Manuals