LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1994 >> Tracker Base, 1.6 6, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VINS [U,6] >> Removal & Installation >> Fuel Pressure Release

Fuel Pressure Release

  1. Place transmission in Neutral (M/T) or Park (A/T). Set parking brake and block wheels. Loosen fuel tank cap to release fuel tank pressure. Disconnect fuel pump relay connector, located under left side of dash. Start engine and allow engine to stall. Crank engine again for an addition 3 seconds, to ensure relief of any remaining pressure.
  2. Disconnect negative battery cable. Connect fuel pump relay connector and tighten fuel filler cap. Cover fuel line or component to be disconnected with shop rag during removal procedure.
scientia non olet · About LEMON Manuals