LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1994 >> Prizm Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [6] & 1.8L 4-CYL - VIN [8] >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

  1. Disconnect negative battery cable. Drain cooling system. Loosen bolts on water pump pulley and remove drive belts. Raise and support vehicle.
  2. Support engine with floor jack. Remove right engine mount. Remove upper and center timing belt covers.
  3. If equipped with power steering, remove front transaxle mount, upper radiator hose and electric cooling fan. On all models, remove engine harness mounting bolt.
  4. Remove coolant inlet pipe. Remove oil dipstick tube, and plug hole in oil pump housing (if necessary). Remove water pump retaining bolts, water pump and "O" ring from cylinder block.
scientia non olet · About LEMON Manuals