LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1994 >> Prizm Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [6] & 1.8L 4-CYL - VIN [8] >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

  1. Ensure all sealing surfaces are clean. Using Seal Installer (J-35388), install seal in seal retainer. Lubricate seal lip with grease.
  2. Tighten bolts to specification. See TORQUE SPECIFICATIONS  . To install remaining components, reverse removal procedure. Ensure reference mark on flywheel/drive plate aligns with mark on crankshaft.
scientia non olet · About LEMON Manuals