Rod Bearings
- Note direction of connecting rod and cap installation before removal. Connecting rod must be installed in original direction. Ensure bearing oil clearance and side play are within specification. See CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS and CONNECTING RODS tables under ENGINE SPECIFICATIONS.
- Rod bearings are available in 3 standard service sizes: I, II and III. These bearing identification marks are stamped on bearing shell and are used to determine bearing thickness. See ROD BEARING SPECIFICATIONS table.
ROD BEARING SPECIFICATIONS
| Identification Mark | Thickness In. (mm) | |
|---|---|---|
| 1.6L | ||
| I (Blue) | .0594-.0595 (1.508-1.511) | |
| II (Black) | .0593-.0594 (1.506-1.508) | |
| III (Brown) | .0591-.0593 (1.501-1.506) | |
| 1.8L | ||
| I (Blue) | .0592-.0593 (1.503-1.507) | |
| II (Black) | .0590-.0592 (1.499-1.503) | |
| III (Brown) | .0589-.0590 (1.495-1.499) | |