LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1993 >> Storm Base, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> NIPPONDENSO 6 & 10-Cylinder Clutch Coil And Bearing R & I >> Removal

NIPPONDENSO 6 & 10-Cylinder Clutch Coil And Bearing R & I: Removal

  1. Hold clutch plate stationary and remove shaft bolt (or nut). Remove clutch plate using puller. Remove shim(s) from shaft and snap ring. Tap pulley off shaft with plastic hammer. If pulley cannot be removed by hand, use commercially available puller.
  2. Remove snap ring, bearing, and seal (if equipped) from pulley. See Figure. Remove screw for clutch coil lead. Remove snap ring and clutch coil.
scientia non olet · About LEMON Manuals