LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1993 >> Prizm Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [6] & 1.8L 4-CYL - VIN [8] >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

  1. Ensure all sealing surfaces are clean. Using Seal Installer (J-35388), install seal in seal retainer. Lubricate seal lip with grease.
  2. Tighten bolts to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article. To install remaining components, reverse removal procedure. Ensure reference mark on flywheel/drive plate aligns with mark on crankshaft.
scientia non olet · About LEMON Manuals