LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1993 >> Prizm Base, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Overhaul - A-240 "E" & "L" Series >> On-Vehicle Service >> Valve Body Assembly R & I >> Removal

Valve Body Assembly R & I: Removal

  1. Clean exterior of transaxle oil pan. Remove drain plug and drain transaxle. Remove oil pan and gasket. Remove oil strainer (filter) and apply tube bracket. Note location of oil tubes. Using large screwdriver, carefully remove oil tubes.
  2. Remove manual detent spring. Disconnect solenoid connector(s). Remove valve body assembly bolts. Note bolt length and location. See Fig 1 and Fig 2 . Remove throttle cable. Disconnect manual valve connecting rod. Remove valve body assembly.
Fig 1: Valve Body Assembly Bolts (A-241E, A-243L & A-244E)
G95F19682Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Valve Body Assembly Bolts (A-245E & A-246E)
G95D19649Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals