LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1993 >> Prizm Base, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Overhaul - A-240 "E" & "L" Series >> On-Vehicle Service >> Valve Body Assembly R & I >> Installation

Valve Body Assembly R & I: Installation

  1. Hold valve body cam downward and install throttle cable in slot. Install manual valve connecting rod. Install valve body assembly. Ensure kickdown switch wire is not pinched under valve body assembly.
  2. Install valve body assembly bolts finger tight. Ensure proper length bolts are installed in correct location. See Figure and Figure . Tighten bolts to 89 INCH lbs. (10 N.m). Connect solenoid connector(s). Install detent spring and tighten bolt to 89 INCH lbs. (10 N.m). Ensure manual valve lever contacts center of roller on detent spring. Using a plastic hammer, tap oil tubes into place.
  3. Install oil tube clamp and bolt and tighten bolt to 89 INCH lbs. (10 N.m). Install oil strainer. Install magnet in oil pan. Ensure magnet does not interfere with oil tubes. Install oil pan and gasket. Tighten oil pan bolts to 43 INCH lbs. (4.9 N.m). Install drain plug and tighten to 13 ft. lbs. (17 N.m). Fill transaxle with fluid and check for leaks.
scientia non olet · About LEMON Manuals