Throttle Cable R & I: Installation
- Install throttle cable in transaxle case. Ensure cable is fully seated. Install retaining bolt. Install valve body assembly. On new throttle cables, stopper must be staked on inner cable. Bend cable in approximately 7.87" (200 mm) radius.
- Pull inner cable lightly, until a slight resistance is felt, and hold in place. Stake stopper on inner cable, leaving a .031-.059" (.78-1.49 mm) gap between cable housing and stopper. See Fig 1.
- Adjust throttle cable and park/neutral position switch (if necessary). See appropriate TRANSMISSION SERVICING article. Install manual shift lever. Install transaxle control cable. Test drive vehicle.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002