Disassembly (A-241E & A-244E)

Remove solenoids. Remove 10 bolts and lower valve body cover. See Fig 1. Remove strainer, gaskets and plate. Remove 8 bolts from upper valve body. See Figure. Remove 9 bolts from lower valve body. See Fig 2. Hold plate against lower valve body and carefully remove lower valve body. DO NOT lose check balls. Note location of check balls, retainers, pins and plugs in valve body. Remove plate and gasket. See Fig 3.

Fig 1: Identifying Lower Valve Body Cover Bolts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Identifying Lower Valve Body Bolts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 3: Exploded View Of A-241E & A-244E Valve Body Assembly

CAUTION: Note position of throttle valve adjusting screw before disassembly. Also note which step at end of primary regulator valve sleeve contacts valve body prior to removal. Line pressure is affected by plunger location. See Figure.