LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1993 >> Prizm Base, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Diagnosis - A-131L & A-132L >> Component Disassembly & Reassembly >> Rear Planetary Gear >> Inspection

Rear Planetary Gear: Inspection

  1. Clean all parts with solvent. Dry parts using compressed air. Check thrust washers and one-way clutch for wear or damage. Replace if necessary.
  2. Using a feeler gauge, measure clearance between planetary pinion gear and planetary gear case. Standard clearance should be .008-.020" (.20-.50 mm). Maximum clearance is .020" (.50 mm). If clearance exceeds specification, replace planetary gear.
scientia non olet · About LEMON Manuals