HARRISON V5 5-Cylinder Shaft Seal R & I: Installation

1. Coat new "O" ring with refrigerant oil and install on "O" Ring Installer (J-33011). Install "O" ring into groove in compressor neck. Attach new seal to seal remover/installer. Dip shaft seal in clean refrigerant oil.
2. Place Seal Protector (J-34614) over compressor shaft. Push new seal over shaft protector. Install new seal snap ring with flat side against seal. Install clutch plate assembly.

Fig 1: Exploded View Of Compressor (Harrison V5 5-Cylinder)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002