Switch Check
Disconnect oil pressure switch wire connector. See OIL PRESSURE SWITCH LOCATION table. Using ohmmeter, measure resistance between switch terminal and ground. Continuity should exist with engine stopped. No continuity should be present when there is oil pressure (engine running). Replace as required.
OIL PRESSURE SWITCH LOCATION
| Model | Location |
|---|---|
| Metro | On Front Of Engine, Above Oil Filter |
| Prizm | On Left Front Of Engine, Above Oil Filter |
| Storm SOHC | On Right Rear Of Engine, Near Oil Filter |
| Tracker | Right Front Of Engine, |
| " | Below Exhaust Manifold |