LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1992 >> Storm Base, 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [6] & 1.8L 4-CYL - VIN [8] >> Overhaul >> Valve Guides

Valve Guides

  1. Check valve stem-to-valve guide clearance. Ensure valve stem diameter is within specification. Valve guide may be replaced if clearance exceeds specification. See CYLINDER HEAD table under ENGINE SPECIFICATIONS at end of article.
  2. To replace valve guide, use hammer and Valve Guide Remover (J-37985). Drive valve guide out from combustion side of cylinder head. Using hammer and Valve Guide Installer (J-38462), drive valve guide into cylinder head.
  3. Measure valve stem-to-valve guide clearance. If clearance is less than .0009" (.023 mm) on intake valves or .0012" (.030 mm) on exhaust valve, ream valve guide.
scientia non olet · About LEMON Manuals