LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1992 >> Storm Base, 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [6] & 1.8L 4-CYL - VIN [8] >> Overhaul >> Fitting Pistons

Fitting Pistons

  1. Different sized pistons are used. Piston size can be determined by identification mark on top of piston. See Fig 1 . Piston identification mark is a letter representing piston diameter.
  2. To determine piston-to-cylinder clearance, measure cylinder bore diameter and piston skirt diameter. On 1.6L, piston skirt diameter must be measured 1.2" (30 mm) from top of piston, at 90-degree angle to piston pin. On 1.8L, measure piston skirt diameter 1.29" (33 mm) from top of piston, at 90-degree angle to piston pin.
  3. Ensure clearance is within specification. See CYLINDER BLOCK table under ENGINE SPECIFICATIONS at end of article. If clearance is not within specification, bore cylinder block for oversized pistons.
Fig 1: Identifying Marks On Piston Top
G91I00404Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals