Samurai & Sidekick
WARNING: This page is about a different car, the 1992 Suzuki Swift, 1992 Suzuki Sidekick, and 1992 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
- Remove rocker cover. Rotate crankshaft until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley.
- Cylinder No. 1 should be at TDC on compression stroke. Remove distributor cap, and ensure rotor is pointed upward at distributor hold-down bolt and to No. 1 terminal of distributor cap. If not as described, rotate crankshaft 360 degrees.
- Measure valve clearance between adjustment screw and valve stem using thickness gauge. Check intake valve clearance of cylinders No. 1 and 2 and exhaust valve clearance of cylinders No. 1 and 3.
- Turn crankshaft one complete revolution (360 degrees). Check intake valve clearance of cylinders No. 3 and 4 and exhaust valve clearance of cylinders No. 2 and 4. Ensure clearance is within specification. See VALVE CLEARANCE SPECIFICATIONS
table.
- If clearance adjustment is necessary, loosen lock nut and turn adjusting screw. After adjusting clearance, tighten adjusting screw lock nut to 11-14 ft. lbs. (15-19 N.m) on Samurai or 90-108 INCH lbs. (10-13 N.m) on Sidekick. On all models, recheck clearance.
VALVE CLEARANCE SPECIFICATIONS
| Application |
In. (mm) |
| SOHC Engines |
| Samurai, Sidekick 8-Valve TBI & Swift |
| Engine Cold |
| Exhaust |
.006-.008 (.15-.20) |
| Intake |
.005-.007 (.13-.17) |
| Engine Hot |
| Exhaust |
.010-.012 (.25-.30) |
| Intake |
.009-.011 (.23-.27) |
| Sidekick 16-Valve PFI |
| Engine Cold: Exhaust & Intake |
.0031-.0047 (.08-.12) |
| Engine Hot: Exhaust & Intake |
.0047-.0063 (.12-.16) |
| DOHC Engine: Swift |
|