LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1992 >> Metro LSi, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Oil Checking >> SANDEN >> 7-Cylinder >> Hyundai Excel & Scoupe, & Mitsubishi Precis

Hyundai Excel & Scoupe, & Mitsubishi Precis

  1. Before checking and adjusting oil level, operate compressor at engine idle speed, and set controls at maximum cooling and high blower motor speed for 20-30 minutes to return oil to compressor.
  2. Stop engine. Discharge refrigerant and remove compressor from vehicle. See SERVICING PRECAUTIONS at beginning of article. Remove oil drain plug and drain oil. Measure amount of oil drained. Install drain plug with new "O" ring.
  3. If amount drained is 2.3 ounces or more, fill with same amount using new oil. If amount drained is less than 2.3 ounces, fill with 2.3 ounces. Install filler plug. Install compressor and recharge system.
COMPONENT REFRIGERANT OIL CAPACITIES (SANDEN 7-CYL-EXCEL, PRECIS & SCOUPE)

Component Ounces
Condenser 1.0
Evaporator 3.0
Receiver-Drier 1
scientia non olet · About LEMON Manuals