LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1992 >> Metro LSi, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.0L 3-CYL - VIN [6] >> Removal & Installation >> Fuel Pressure Release

Fuel Pressure Release

  1. Set parking brake. Place transaxle in Neutral (M/T) or Park (A/T). Fuel pump relay must be removed. Fuel pump relay is located in main fuse box, at left side of engine compartment. Refer to Fig 1.
  2. Remove main fuse box retaining screws. Release locking tabs on fuel pump relay and remove from main fuse box. Disconnect electrical connector from fuel pump relay.
  3. Start engine and operate until it stalls. Crank engine an additional 3 times for 3 second intervals to release residual fuel line pressure. Remove fuel tank filler cap to release pressure from fuel tank.
  4. Fuel pressure should now be released and fuel pump relay can be installed.
Fig 1: Removing Fuel Pump Relay
G91C00440Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals