LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1992 >> Metro LSi, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (1.3L 4-CYL - VIN [3] & 1.6L 4-CYL - VIN [0]) >> Engine Lubrication >> Oil Pump >> Reassembly & Installation

Reassembly & Installation

WARNING: This page is about a different car, the 1991 Suzuki Swift, 1991 Suzuki Sidekick, and 1991 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure gears are assembled in same direction as originally installed. Apply thin coat of engine oil to inner and outer rotors, lip portion of oil seal and inside surfaces of oil pump case and plate. Install inner and outer rotors.
  2. Install gear plate. Ensure gears turn freely by hand after gear plate is installed. Install oil pump pins, new dipstick "O" ring, new seal for oil pick-up tube and new oil pump gasket. Use Oil Seal Guide (09926-18210) to prevent damage to oil seal during installation of oil pump.
  3. Apply engine oil to guide, and install pump. Install dipstick guide with new seal. Install oil pan using silicone-type sealant. Tighten bolts to specification. See TORQUE SPECIFICATIONS  table.
Fig 1: Checking Oil Pump Radial Clearance
G81641Courtesy of SUZUKI OF AMERICA CORP.
Fig 2: Checking Oil Pump Side Clearance
G81642Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals